Inverters › Deye › 8kW Single Phase Hybrid
8kW Single Phase Hybrid
8kW Single Phase Hybrid
Deye
SUN-8K-SG05LP1-EU
Automations Cloud bypass MQTT API Read via cable Read via network Real time Setting control
Overview › Solarman WiFi dongle

WiFi dongle

First, it is important to make sure that the SolarAssistant and the Solarman dongle are connected to the same Access point or router. This means you will have to have the initial setup for the Solarman dongle to get it connected to the router. Once you have them both connected to the same router, open the configuration page.

On the SolarAssistant configuration page, select "Deye" inverter and then "Configure network connections".

Select Deye inverter

Then, open the Configure network connections page.

Select wifi configuration

Once on that page, you should see a scan button. This will scan the connected network for Deye dongles.

Scan network

Note: If you are not finding a dongle, check that the dongle is using an IP address within the range shown, and there is a network log on the right-hand side to help with diagnosis.

Once you have the dongle selected, save and highlight the device on the configuration tab, then click connect:

Select connect