General
Introduction Is my inverter supported? FAQ Reporting issues Transfer license to new device
Getting started
Preparing device Starting device - ETH Starting device - WiFi Starting device - No internet Video output
Deye/SunSynk/Sol-Ark
Configuration The 2 in 1 BMS port Settings Power management
Voltronic/Axpert/MPP Solar
Configuration Settings Power management
Growatt
SPF range SPH range SPA range TL range Settings Power management
EASUN/PowMr/Powland
Configuration
EG4
Configuration EX/EHV Settings 18KPV Settings
Luxpower
Configuration Settings
Megarevo
Configuration
MUST
Configuration Settings
Battery
Configuration CAN bus CFE battery Daly BMS Dyness / Mecer EG4 Felicity Solar Giter JK BMS JBD / Overkill BMS Revov Seplos BMS Shoto BMS SOK SolarMD SunSynk Trophy Vestwood
Grid
Eskom Europe
Device Access
Overview Android iPhone Bluetooth Regions Troubleshooting
Dashboard
Overview Inverter Battery
Historic data
Charts Totals Export Backup
User management
Overview Transfer site
Automation
Rule table
Home Assistant
Setup Broker setup Energy dashboard Adjusting solar settings
Integration
MQTT API Node-RED
Software updates
Overview Changelog Beta program
Example installations
Axpert parallel with Pylontech SunSynk with Pylontech
Shop
Generate proforma invoice

Adjusting Voltronic inverter settings

Step 1 - Navigate to inverter settings

On the configuration tab, navigate to the inverter settings page.

Open Voltronic inverter settings

Step 2 - Enter edit mode

If you have parallel inverters, select the inverter. Select edit on section you would like to edit.

Select Voltronic inverter

Step 3 - Change setting and save

Change the setting you would like to adjust and press save.

Change Voltronic inverter setting

Troubleshooting

If any setting change is not working as expected, please try adjusting it with the official WatchPower or SolarPower app from a laptop. If it works correctly from the official app but not from SolarAssistant, please contact us so that we can correct the problem in SolarAssistant.

Troubleshooting - Axpert Hybrid, Revo VM II, ISolar SMR II

If your inverter is shown in SolarAssistant as Axpert Hybrid under "configuration -> settings" then there is a good chance that the inverter will reject most setting changes from SolarAssistant and also the official WatchPower or SolarPower app. When investigating one of these units, we confirmed that the firmware the inverter is loaded with does not support changing settings via the communication ports.

Troubleshooting - MPP Solar LVX-6048

Some of the inverter settings are only editable via a RS232 cable and not via a micro USB cable. If you use the official MPP Solar desktop WatchPower app you will see the same behaviour.

©2024 SolarAssistant
Website terms and conditions | Software end user agreement | Contact us